To Next PageTo Next Page
Need help?Do you have a question about the Omron STC-HD213 Series and is the answer not in the manual?
General| Brand | Omron |
|---|---|
| Model | STC-HD213 Series |
| Category | Digital Camera |
| Language | English |
Lists key features of the STC-HD213 series cameras.
Explains the naming convention for STC-HD213 camera models.
Lists optional peripheral equipment supplied for the cameras.
Details electronic specifications including image sensor, output, and camera functions.
Provides spectral sensitivity data for the camera sensors.
Details physical dimensions, materials, and connectors of the camera models.
Outlines operational and storage conditions, vibration, and shock resistance.
Describes the circuit diagram for external switch control via a 3.5mm jack.
Provides detailed dimension drawings for STC-HD213DV and STC-HD213DVN models.
Shows dimension drawings for STC-HD213DV-CS and STC-HD213DVN-CS models.
Presents dimension drawings for STC-HD213SDI and STC-HD213SDIN models.
Details dimension drawings for STC-HD213SDI-CS and STC-HD213SDIN-CS models.
Explains how to set White Balance using the camera's push button.
Describes how to configure camera settings using an external switch or remote controller.
Lists the system requirements for the control software.
Outlines the steps for connecting and launching the control software.
Explains the function of each button in the control software interface.
Differentiates between uCOM and DSP register areas for camera control.
Provides a detailed description of various functional settings available in the software.
Defines the communication parameters like baud rate, data bits, and parity.
Details the data format for sending and receiving commands between PC and camera.
Lists available commands for controlling the camera via communication protocols.
Provides a list of slave addresses for various ICs used in the camera system.
Lists error codes and their corresponding receive data for troubleshooting.
Maps uCOM registers to their addresses, descriptions, and default values.
