34
Section 2V600-CH1D-V2 Communications Preparation
RFID System
User's Manual
Section 2
Communications Preparations
When connecting to a CQM1, CJ1, CS1, etc.
Prepare a connection cable as shown in the connection examples below.
Note: Because both the V600-CH1D-V2 interface connector and the interface connector of the
CQM1, CJ1, and CS1 are sockets, a conversion connector is necessary to connect them. Also,
the pin arrangement of the CQM1, CJ1, and CS1 interface connector is different from the RS-
232C pin arrangement of a personal computer.
V600-CH1D-V2 CQM1/CJ1/CS1
Pin No. Signal Pin No. Signal
1 --- 1 ---
2RD 2SD
3SD 3RD
4 --- 4 RS
5SG 5CS
6 DS 6 ---
7 RS 7 ---
8 CS 8 ---
9 --- 9 SG
To Next Page
Loading...
