Omron ZEN - Page 20

6 Creating the Program ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 20
6.3.3. Writing a Parallel Line (OR)
6.3.4. Vertical Connection Lines
Press “OK (1)”.
Select Q (CPU output bit) using the “
⇑
⇑⇑
⇑
(5)”
key.
Confirm writing the contact by pressing “OK
(1)” twice.
Press “ALT (7)” to enable entering the
vertical connection line option.
The vertical and horizontal connection
lines are inserted using the “
⇑
⇑⇑
⇑
(5)” key.
The (+) symbol indicates the
intersection.
Pressing “OK (1)” confirms writing the
connection lines.