6 Creating the Program ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 19
6.3.2. Writing Outputs
First, before entering the output relay, the union line has to be inserted as
follows:
Once the line has been inserted, the cursor is situated on the right of the
program line and the output relay is entered:
Press “ALT (7)” to select the N.C. input.
Use the “♣
♣♣
♣(4)” key to move the cursor
and press “ ⇑
⇑⇑
⇑
(5)” to change the bit
address to 1.
Press “OK (1)” again to enter another
N.A. contact in series with the previous
contact.
Press “OK (1)” to enter another new
N.A. contact in series with the previous
contacts. This creates the automatic
connection between the first two
contacts entered.
Press “ALT (7)” to enable entering the
connection line option.
The connection line is definitively set up
with the “♣
♣♣
♣(4)” key.
Press “OK (1)” to enter an initial Q0
output. The output type can be selected
using the “
⇑
⇑⇑
⇑
(5)” and “
⇓
⇓⇓
⇓
(2)” keys.
Press “OK (1)” twice to confirm writing
Q0 output. The cursor will automatically
go to the next line of the program.
To Next Page
Loading...
