Omron ZFX-C - Initializing Controller Settings

About Communication Commands
ZFX-C Serial Communication Command Reference
33
Uploading System Data < SYSLOAD command >
Uploading system data to the Controller from an external device
This command uploads the system data to the Controller by XMODEM protocol.
No parameters are provided for this command.
< Command format >
< File transfer >
The system data is transferred by XMODEM (-CRC or SUM) after READY is received. XMODEM (-1K) is not
supported.
< Response format >
Uploading system data to the Controller from an SD card
This command uploads system data to the Controller from an SD card.
< Command format >
< Response format >
< Explanation of parameters >
File name Specifies the file name within eight alphanumeric characters. (An extension is not
required.)
S Y S L
C
R
S L
C
R
O A D 00
or
OK
C
R
ER
C
R
R EAD
C
R
Y
When processing ends successfully
When processing fails
S Y S L
C
R
S L
C
R
O A D11
File name
or
File name
OK
C
R
ER
C
R
When processing ends successfully
When processing fails