15
Note: The meter allows the hyperglycemia level to be as low as 6.7 mmol/L
(120 mg/dL) or higher. The hyperglycemia level should be above the
hypoglycemia level. Consult your diabetes healthcare professional before
determining what your hyper blood glucose level is.
9. Hypo Indicator: The meter comes with the Hypo indicator feature disabled.
Press the ◄ button to turn the Hypo indicator “On” or “Off”. Press the ► button
to confirm your selection. When the Hypo indicator is “Off,” pressing the ►
button will go to the Test Reminder set up. When the Hypo indicator is “On”,
pressing the ► button will go to the Hypo indicator level set up. At the Hypo
level set up, press the ◄ button to adjust the Hypo level. Then press the ►
button to go to the Test Reminder set up.
Note: The meter allows the hypoglycemia level to be as high as 5.6 mmol/L
(100 mg/dL). The hypoglycemia level should be below the hyperglycemia level.
Consult your diabetes healthcare professional before determining what your
hypo blood glucose level is.
10. Test Reminder: Test reminders are a useful way to remind you when to test.
You can set 1 to 5 reminders per day. Your meter is preset with the test
reminder disabled. You must turn it on to use this feature.
• Press the ◄ button to turn the first Test Reminder “On” and “Off”. Press the
► button to confirm your selection. When the Test Reminder is “Off”,
pressing the ► button will go to the setup of the second Test Reminder.
When the Test Reminder is “On”, pressing the ► button will go to the setup
of the time for the first Test Reminder. Press the ◄ button to adjust the first
Test Reminder time (Time is adjusted by every minute). Press the ► button
to confirm the first Test Reminder time and then go to the second Test
Reminder set up.
• When the Test Reminder is “Off” during the second Test Reminder set up,
pressing the ► button will go to the setup of the third Test Reminder. When
the Test Reminder is “On”, pressing the ► button will go to the setup of the
time for the second Test Reminder. Press the ◄ button to adjust the
OR