WWW.ONEFORALL.COM 9OM
Search Method
--> If your device does not respond to the KAMELEON 3 after you have tried
all the codes listed for your brand.
--> If your brand is not listed at all.
The Search Method allows you to scan through all the codes contained in the
memory of the
KAMELEON 3.
Example: To search for your TV code:
1.
Switch ON your Television (not on standby).
2. Press the TV key on your KAMELEON 3.
3. Press and hold down the MAGIC key (for about
3 seconds) until the rabbit comes out of the hat.
4. Press 9 9 1, the IR Indicator will light up twice.
5. Next, press POWER.
6. Point the KAMELEON 3 at your Television. Now press CH+
over and over, until your Television turns off (every time
you press the CH+ key the KAMELEON 3 will send out a POWER
signal from the next code contained in the memory).
You may
have to press CH+ many times (up to 150 times) so
please be patient. Remember to keep pointing the
KAMELEON 3 at your Television while pressing this key.
If you skip past a code, you can go to the previous code(s) by
pressing the CH - key.
7. When your Television switches off, press the
MAGIC key to store the Code. The IR Indicator
will light up twice. Now your KAMELEON 3
should be ready to control your television.
- Most TV’s do not switch on pressing the POWER key. Please try pressing a
“number” key or the “TV-text off” key to switch your TV back on.
- If you cannot control your Television properly, please continue the Search
Method, you may be using the wrong Code.
- To search for the code for another device follow the instructions above only
press the appropriate device key instead of TV during step 2.
- If the original remote control of your Video recorder or DVD player does
not have a POWER key, press PLAY instead of POWER during step 5.
Setting up the KAMELEON 3
To Next Page
Loading...
