12 WWW.ONEFORALL.COM
The KAMELEON 3 comes with a complete library of pre-programmed codes.
After you have set up the KAMELEON 3 for your device, you may find that there
are one or more keys that you had on the original remote control, which do not
have a place on the KAMELEON 3 keypad. The KAMELEON 3 offers a special
Learning feature that allows you to copy almost any function from your original
remote control onto the keypad of the
KAMELEON 3.
Before you start:
- Make sure your original remote is working correctly.
- Make sure neither your
KAMELEON 3, nor your original remote control is
pointing at your device.
Learning (direct)
Example: To copy the “mono/stereo” function from your original TV
remote control onto the ”16:9”-key of your
KAMELEON 3.
1. Place the KAMELEON 3 and your original remote control on a flat
surface. Make sure the ends which you normally point at your device
are facing each other. Point the original remote to the front of the
KAMELEON 3 (see picture below). Keep the remotes at a distance of 2
to 5 cm (0.8 to 2 inches).
2 Press and hold down the MAGIC key
(for about
3 seconds) until the rabbit comes out of the hat.
3. Press 9 7 5. The IR Indicator will blink twice.
4. Press the device key (Example: TV key) on the KAMELEON 3
remote to select the mode to which you want to copy the
learned function.
5. Press the key (Example: ”16:9” key) on the KAMELEON 3
remote where you want to place the learned function. The IR
Indicator will blink three times and then the display will
switch off.
6. Press and hold the key that you want to copy (Example:
mono/stereo) on your original remote control. The display
switches back on and you will see two blinks to indicate
successful learning operation.
Learning Feature
(How to copy functions from your original working remote onto the
KAMELEON 3)
To Next Page
Loading...
Need help?
General
