onga JSP110 - User Manual

Questions and Answers

P
Paula MunozAug 8, 2025
What to do if my Onga Water Pump does not start?
- J
  Joseph WardAug 8, 2025
  If your Onga Water Pump isn't starting, ensure it's connected to a live outlet. Also, check the circuit breakers and fuses. If the pressure controller detects no water in the tank, make sure there's enough water and press the reset or start button. A blocked pump can also be the cause; disconnect it from the power and inspect the housing and discharge for any obstructions. If none of these steps work, the capacitor may be defective, and you should call a qualified service technician.
K
Kevin MitchellAug 13, 2025
Why does my onga JSP110 have poor performance with low pressure?
- S
  Sharon RoyAug 14, 2025
  To troubleshoot low pressure or flow in your Onga Water Pump, first, check the suction line for leaks, especially at the joints. If the tank water level is too far below the pump, consider discussing a better pump option with your Onga dealer or moving the pump closer to the tank. Also, a worn or damaged pump can cause poor performance, so ask your Onga dealer to investigate worn parts.
R
Rebecca GrahamAug 19, 2025
What to do if there is no water from onga JSP110?
- Z
  Zachary StrongAug 19, 2025
  If your Onga Water Pump isn't providing water, first ensure the pump body and suction line are filled with water before starting. Check the suction line for leaks, particularly at the joints. Blockages in the pump or discharge can also prevent water flow, so disconnect the pump from power and inspect for foreign matter. Make sure all valves on the tank, pump, and outlets are open. If the tank doesn't have enough water, wait until it refills and then press the reset or start button on the pressure controller. Also, check and clean the pump if it's not producing enough pressure, and inspect/clean any in-line or tap filters that may be blocked. Finally, check system pressure and adjust the pressure switch accordingly.
E
Emily TaylorAug 26, 2025
Why does my onga JSP110 Water Pump run intermittently?
- H
  Harry HuntAug 26, 2025
  If your Onga Water Pump runs intermittently, start by checking for small leaks in your household plumbing and fix them. Ensure that the water temperature remains within the specified limits. Verify that the voltage is within the allowable limits as stated in the specifications, and correct if necessary. Also, make sure there's adequate ventilation for the motor cooling fan.
S
sarah06Aug 31, 2025
What to do if onga JSP110 will not stop?
- M
  matthew27Aug 31, 2025
  If your Onga Water Pump won't stop, even with no taps open, debris might be caught in the pressure controller; take it to your Onga dealer for service. Also, check for leaks in the household plumbing and fix them.