Onicon FT-3200 - IP ADDRESS SETTING (Ipv6)

FT-3200 MODBUS TCP/IP SUPPLEMENT
ONICON Incorporated • 727.447.6140 • www.onicon.com
Page 7
1.7 IP ADDRESS SETTING (IPv4) (CONTINUED)
1.8 IP ADDRESS SETTING (IPv6)
Seven pages are available from the main menu:
Home – The page you currently see. This page is not used to congure the IP address.
Port1 – Not used.
Network – This page allows you to change the IP address settings.
Filter – Not used.
Monitor – Not used.
Password – This page can be used to change the password from the default admin.
Logout – Press this button to logout of the FT-3200 IP congurator.
Press the Network button to arrive at the following page:
Within the IP Address Selection section, you can congure the IP settings for the FT-3200’s MODBUS communications.
After the conguration has been updated, press the Update Settings button to save the changes. Document the
conguration chosen. After pressing the update button, if you need to access these settings again, you must go back into
your PC’s IP setting page and change the IP address and subnet to match the network the FT-3200 is set for.
After you are done making conguration changes, you are ready to connect the FT-3200 to the
MODBUS TCP/IP network.
Address Type – Choose between Static IP, and DHCP. The Static IP Address, Subnet Mask, and Default Gateway will
become un-editable if DHCP is selected.
The default meter IPv6 address is shown in the eld highlighted in yellow below. This section is part of the web browser
interface Network tab. Use the eld outlined in red below to enter a new IPv6 address for the meter.
Press Update Settings button to save the change.