Onida 21IQ - Colour Adjustment (PAL

A d j u s t m e n t M a n u a l I
2
C
Item Colour Adjustment (PAL) Adj.Process 2AL
3G(UE-DLX)
M o d e l ALL
Measuring
Equipment
* Oscilloscope
Preparation
before Adj.
* Warm up the receiver for more than 30 minutes.
* Adjust the PICTURE MODE to [DYNAMIC] mode.
Adjustment 1) Receive the PAL colour bar pattern signal .
2) Connect the probe of the oscilloscope to
green cathode.
3) Select Sub color in the Service Menu.
4) Adjust the Sub color so that the value
between the white peak & blue as per
below table.
Model Adj.Point
14/20/21” +3V
Note: While entering in the SERVICE MENU by default it takes the
value of VSM cartoon, hence the above parameter is adjusted with
respect to cartoon condition.
15