Onkyo A-SV210 User Manual

Recording a source
—_ Tape deck
(TAPE-1, TAPE-2)
2
VIDEO-1.VDP VIDEO-2/VCR TAPE-1 TAPE-2 MONITOR TUNER
SS] ao o
©
Tape deck (TAPE-2
TAPE-2 MONITOR
=
Please read the instruction manuals con-
cerning the operation of each unit.
1.
2.
3.
Insert a blank tape into the tape deck.
Press the button of the source from
which you want to record.
When VIDEO-I/VDP or VIDEO-2/
VCR is selected, it will (naturally) only
record the audio.
When TUNER is selected, set the tuner
to the station you want to record from.
When TAPE-1 is selected, it will record
to the TAPE-2 REC jacks.
When either VIDEO-I/VDP, VIDEO-
2/VCR, TUNER, PHONO or CD is
selected, you are able to record to both
the TAPE-1 and TAPE-2 REC jacks.
Put the tape deck in the recording
mode. Begin playing the source.
Set the proper recording level using the
controls on the tape deck used for record-
ing. Also, during recording and dubbing
operations, if any controls (bass, treble
etc.) on this unit are changed during
recording and dubbing operations, the tone
effects will not change.
1,
2.
3.
Load the original tape in deck 1 and
the blank tape in deck 2.
Press the TAPE-1 button.
Put tape deck 1 in the playback mode
and tape deck 2 in recording mode.
The source signal can be monitored
through the speakers or headphones
when TAPE-2 MONITOR is turned off.
If tape deck 2 has three heads, the just-
recorded signal can be monitored (when
the TAPE-2 MONITOR is turned on).
Refer to the tape deck instruction manual
for more details.

Onkyo A-SV210 Specifications

General

Brand	Onkyo
Model	A-SV210
Category	Amplifier
Language	English