EasyManuals Logo

Onkyo CR-N775D User Manual

Onkyo CR-N775D
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
> Before Start > Part Names > Install > Initial Setup >Playback
Supplementary information | Advanced Setup | Others
20
Listening to the FM Radio
Tuning Automatically
Perform the following procedure when the unit is on.
1. Repeatedly press INPUT 2/1 on the remote
controller to switch input to FM.
2. Repeatedly press ENTER (b) on the remote
controller so that "AUTO" appears on the display.
3. When you press TUNE 3/4 (a) on the remote
controller, automatic tuning starts, and searching
stops when a station is found. When tuned into an
FM station, is displayed. During stereo
reception "STEREO" is displayed and during
monaural reception "MONO" is displayed.
When FM broadcasts reception is poor: Perform the
procedure for "Tuning Manually" in the following
section. Note that if you tune manually, the reception
for FM broadcasts will be monaural rather than stereo,
irrespective of the sensitivity of the reception.
Tuning Manually
Perform the following procedure when the unit is on.
1. Repeatedly press INPUT 2/1 on the remote
controller to switch input to FM.
2. Repeatedly press ENTER (b) on the remote
controller to turn off "AUTO" on the display.
3. While pressing TUNE 3/4 (a) on the remote
controller, select the desired radio station.
0 The frequency changes by 1 step each time you
press the button. The frequency changes
continuously if the button is held down and stops
when the button is released. Tune by looking at
the display.
0 After pressing skip (:/9) dial on the main
unit until the frequency display flashes, you can
turn the dial left or right to tune stations.
1
3
2
FM
MHz
AsbSTEREO AUTO
a
b

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo CR-N775D and is the answer not in the manual?

Onkyo CR-N775D Specifications

General IconGeneral
Receiver type-
Input sensitivity400 mV
Pre-out connectivityYes
Audio output channels2.0 channels
Power output per channel (20-20KHz@8 Ohm)- W
USB ports quantity2
Digital audio optical in1
DisplayLCD
Apple dockingNo
Product colorBlack
Center speaker impedance16 Ω
Connector contacts platingGold
Headphone connectivity3.5 mm
Audio formats supportedALAC, CBR, DSD, FLAC, MP3, MP3 VBR, MQA, WAV
Bluetooth version4.1
Bluetooth profilesA2DP, AVRCP
FM band range87.5 - 108 MHz
Supported radio bandsDAB+, FM
Internet radio services supportedDeezer, Spotify, Tidal, TuneIn
Optical drive typeCD player
Disc types supportedCD, CD-R, CD-RW
AC input voltage220-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)2.9 W
Power consumption (typical)36 W
Package weight3800 g
Cables includedAC
Package depth276 mm
Package width345 mm
Package height235 mm
Weight and Dimensions IconWeight and Dimensions
Depth295 mm
Width215 mm
Height117 mm
Weight2700 g

Related product manuals