66
Customizing the Source Names
You can change the source name that appears in the display to suit any component you con-
nected per the instructions on page 15.
About short source names
The short source names appear in the display
depending on the situation. Check the short names in
the table below.
1
Press INPUT / until the
source whose name you wish to
change appears in the display.
You can select CD-R, TAPE, LINE, or
DIGITAL.
2
Press EDIT/NO/CLEAR repeat-
edly until “Name Select?”
appears in the display.
3
Press MULTI JOG.
4
Turn MULTI JOG to select a new
name for the source.
Depending on the source you’ve
selected in step 1, the name changes in
the following order:
“Complete” appears in the display.
3-5
2
1
DISPLAY
CD-R
PC
DAT
HD MD2
VCR
TAPE
HD
DAT
MD2
VCR
LINE
GAME TV
DVD BS
DSR CS
VIDEO
DISC
*1 Select this if you connected a third-
party USB component that does not
support connection.
*2 Select this if you connected an
Onkyo USB component that supports
connection.
5
Press MULTI JOG to enter the
new name.
You may press YES/MODE instead of
MULTI JOG to get the same result.
Ordinary names Short names
BS BS
CD-R CR
CS CS
DAT DT
DVD DV
DSR DR
GAME GM
HD HD
LINE LI
MD2 M2
PC PC
TAPE TA
TV TV
VCR VC
VIDEO DISC VD
To Next Page
Loading...
