Connecting the AV Receiver
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURROUND BACK or FRONT HIGH k terminals.
Surround back/ Surround back/
front high front high
right left
7.1chUSEONLV
SU_OUN_BACK
Or_RONTHIGH
Surround Surround
rli ht left
SURROUND
Center
CENTER
Front right
Front left
• You call specify whether surround back o1"front high speakers are connected ill the "Sp Config (Speaker Configuration)" menu
(_ page 36) or during Audyssey 2EQ (!')Room Correction and Speaker Setup (_ page 24).
N Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from
the ends of the speaker cables, and twist the bare
wires tightly, as shown.
1/2" to 5/8" (12 to 15 mm)
N Banana Plugs (excluding Asian models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
ER
11
To Next Page
Loading...
Need help?
General
