Onkyo HT-R590 Instruction Manual

You can reset a REMOTE MODE to its default remote
control code.
1
2
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until the
remote indicator lights (about 3 seconds).
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
You can reset the remote controller to its default settings.
1 While holding down RECEIVER, press and hold
down HOMEuntil the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
By pressing REMOTE MODE that's been programmed
with the remote control code for your component, you can
control Onkyo component as below.
For details on entering a remote control code for a
different component (_ page 47).
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the 1-411-11_'1.
The component must be able to receive remote control
commands via r'411-11O and be connected to the AV
receiver via HDMI.
Use the following remote control codes:
32910/33001/31612:
Blu-ray Disc/DVD player with r411-11O
"1 The [-'411-1lO supported by the AV receiver is the CEC
system control function of the HDM[ standard.
En
48

Onkyo HT-R590 Specifications

General

Type	AV Receiver
Channels	7.1
HDMI Inputs	4
HDMI Outputs	1
Total Harmonic Distortion	0.08% (1 kHz, 1 W)
Input Sensitivity and Impedance	200 mV/47 k-ohms (Line)
Dolby Support	Dolby TrueHD, Dolby Digital Plus
DTS Support	DTS-HD Master Audio
Signal-to-Noise Ratio	106dB