Onkyo HT-R590 Instruction Manual

Turning On/Off the AV Receiver
OON/STANDBY
ii
...................... ii.......... , ........
.........:,i!i,I........ii!!!iil;,ii;_ ,5
@
1
Press O ON/STANDBY on the front panel.
or
Press RECEIVER followed by O on the remote controller.
The AV receiver comes on, the display lights.
[o//j
1 Press O ON/STANDBY on the front panel.
or
Press RECEIVER followed by O on the remote controller.
The AV receiver will enter standby mode. To prevent any loud surprises when you turn on the AV receiver, always
turn down the volume before you turn it off.
• See "Auto Standby" about a power management setting (_ page 41),
Erl
18

Onkyo HT-R590 Specifications

General

Type	AV Receiver
Channels	7.1
HDMI Inputs	4
HDMI Outputs	1
Total Harmonic Distortion	0.08% (1 kHz, 1 W)
Input Sensitivity and Impedance	200 mV/47 k-ohms (Line)
Dolby Support	Dolby TrueHD, Dolby Digital Plus
DTS Support	DTS-HD Master Audio
Signal-to-Noise Ratio	106dB