Onkyo HT-R590

Listening Mode
Dolby Digital
Dolby Digital Plus*6
Dolby TrueHD
DTS
DTS-HD High
Resolution Audio
DTS-HD Master
Audio
DTS Express
DSD*7
DTS 96/24
DTS-ES Discrete_8
DTS-ES Matrix*8
Neo:6
iv
Description
[n this mode, audio fi'om the input source is output without surround-sound
processing. The speaker configuration (presence of speakers), crossover
fi'equency, speaker distance, A/V Sync and much of the processing set via
Home menu are enabled. See "Advanced Setup" for more details
(÷ page 34).
This mode is for use with DTS 96/24 sources. This is high-resolution DTS
with a 96 kHz sampling rate and 24-bit resolution, providing superior
fidelity. Use it with DVDs that bear the DTS 96/24 logo.
This mode is for use with DTS-ES Discrete soundtracks, which use a
discrete surround back channel for true 6.117. l-channel playback. The seven
totally separate audio channels provide better spatial imaging and 360-
degree sound localization, perfect for sounds that pan across the surround
channels. Use it with DVDs that bear the DTS-ES logo, especially those with
a DTS-ES Discrete soundtrack.
This mode is for use with DTS-ES Matrix soundtracks, which use a matrix-
encoded back-channel for 6.1/7. l-channel playback. Use it with DVDs that
bear the DTS-ES logo, especially those with a DTS-ES Matrix soundtrack.
This mode expands any 2-channel source for up to 7. l-channel playback. It
uses seven full-bandwidth channels of matrix decoding for matrix-encoded
material, providing a very natural and seamless surround sound experience
that fully envelops the listener.
Neo:6 Cinema
Use this mode with any stereo movie (e.g., TV, DVD, VHS).
Neo:6 Music
Use this mode with any stereo music source (e.g., CD, radio, cassette, TV,
VHS, DVD).
This mode uses Neo:6 to expand 5.l-channel sources for 6.1/7. l-channel
playback.
Speaker
Layout
Ni1NN[_il
Ni1NN[_il
[NillNi11_-l*2
[NillNilI_-I
[NillNi11_-l*2
[NilNNNil
[NilNNI_-I_2
[NillNilI_-I
[NilNNI_-I_2
Ni1NN[_il
[NilNNNil_5
"1 These listening modes cannot be selected during USB or iPod playback.
*2 When the input source contains the encoded front high channel, front high speakers output the sound.
*3 If there are no surround back speakers, Dolby Pro Logic II is used.
*4 Surround back speakers are not supported.
*5 Front high speakers are not supported.
*6 For the Blu-ray Discs, Dolby Digital is used in a 3.1/5. l-channel speaker system.
*7 AV receiver can input the DSD signal from HDM[ IN. Setting the output setting on the player side to PCM might obtain a better
sound according to the player. [n that case, set the output setting on the player side to PCM.
*8 If there are no surround back speakers, DTS is used.
• The listening modes cannot be selected with some source formats.
Ell
30