Onkyo K-611 User Manual

Connecting Series Components
If the K-611 is properly connected to another Onkyo component bearing the 1 mark, you will be able to control the K-611 using
the other component’s remote control.
The upper and lower remote control jacks
have the same function
For remote control operation, connect this
jack and any Onkyo amplifier, receiver or
CD player bearing the —Q| mark using the
remote control cable.
Note:
Do not attempt to connect the (RI remote
control jack to any equipment other than an
Onkyo component bearing the (21 mark.
~ Doing so could cause the unit to malfunc-
. tion.
| The functions listed below can be ac-
~ complished using the remote control of the
- master unit.
: a : Open/Close
> : Play
“« : Rewind
»>
a
: Fast forward
: Stop
CLL : Rec/Pause
© Once c de as shown at left,
_ this function becomes operational. It
, automatically starts recording on the cas-
. Sette deck when the & button of the CD
om, Player is pressed. (See page 11.)
If this unit, a tuner or a CD player from the Onkyo Liverpool Separate Collection Series is connected to an amplifer or receiver
from the same series, the following functions are possible.
ais us
Timer play (once): The component of your choice (CD player, Sleep timer: You can set the timer to shut off power to the system
tape
deck
or
tuner)
begins
to
play
at
a
preset
time
designated
by
after
a
specific
period
of
time
has
elapsed.
The
maximum
sleep
you.
timer
duration
is
90
minutes.
Timer play (every day): The component of your choice (CD
player, tape deck or tuner) begins to play each day at a preset time
designated by you.
Timer recording: By setting up the timer and tuner properly you
can automatically record radio broadcasts at times specified in ad-
vance.
e Refer to the instruction manual of the
Onkyo Liverepool Separate Collection Series tuner for more
detailed instructions.
42

Onkyo K-611 Specifications

General

Brand	Onkyo
Model	K-611
Category	Tape Deck
Language	English