Onkyo T-4355

14
Turning On the T-4355
Using the A-9355/A-9155’s Remote
Controller
If you’re using the T-4355 together with the
A-9355/A-9155 Onkyo amplifier, press the remote con-
troller’s [ON] button to turn on the T-4355 and
A-9355/A-9155. (Plug the T-4355 power cord into the
A-9355/A-9155 AC OUTLET.)
Memory backup
The T-4355 uses a battery-less memory backup system
in order to retain radio presets and other settings when
it’s unplugged or in the case of a power failure.
Backup data can be stored incorrectly or destructed, and
lead to a malfunction if either of the following opera-
tions is performed:
• turning off the power immediately after an operation.
• repeating the fast power on/off switchings.
When a malfunction occurred due to those operations,
initialize T-4355 to its factory defaults. Radio presets
and other settings are deleted.
To initialize T-4355, press the [DISPLAY] button while
holding down the [FM MODE] button.
When the power is turned off while the Auto Preset is
running, T-4355 is initialized to its factory defaults.
Listening to the Radio
1
Plug the power cord into a suit-
able wall outlet (or the AC OUT-
LET on the A-9355/A-9155’s rear
panel).
2
Press the T-4355’s [POWER]
switch.
The T-4355 turns on.
To turn off the T-4355, press the
[POWER] switch.
POWER
ON
RC-627S (remote controller supplied
with the A-9355/A-9155)
Tuning into Radio Stations Manually
1
Use the [BAND] button to select
FM or AM.
The band switches between FM and
AM each time you press the button.
2
Use the TUNING [ ]/[ ] buttons
to tune into a station.
The tuning frequency is shown on the
display.
For each button press, the frequency
will change in 0.05 MHz steps for FM,
and 9 kHz steps for AM.
If you hold down the button for more
than 0.5 second, the T-4355 will find
the next station automatically.
TUNING
BAND