Onkyo T-4355 User Manual

8
Remote Controller
 BAND button (14)
This button can be used to select the FM or AM
band.
If the T-4355 and A-9355/A-9155 are connected
with an cable, pressing this button while the
entire system is on Standby will turn on only the
T-4355 and A-9355/A-9155. All other components
will remain on Standby.
 FM MODE button (18)
This button can be used to set the FM mode to ste-
reo or mono.
 PRESET [+]/[–] buttons (18)
When the input source on the A-9355/A-9155 is set
to TUNER, these buttons can be used to select pre-
sets.
 TUNING [ ]/[ ] buttons (18)
When the input source on the A-9355/A-9155 is set
to TUNER, these buttons can be used to tune into
stations.
* Any remote controller for Onkyo amplifier is avail-
able to control T-4355 in a condition of the connec-
tion. (On some remote controllers, some buttons shown
in the figure are missing. The corresponding functions
cannot be controlled by the remote controller.)
RC-627S Remote Controller (supplied with the A-9355/A-9155 Integrated Ampli-
fier)





Onkyo T-4355 Specifications

Power

power supply voltage	AC 220–230 V
power supply frequency	50/60 Hz
power consumption	9 W

FM Tuner Specifications

FM tuning frequency range	87.5 MHz–108 MHz
FM usable sensitivity (Stereo)	17.2 dBf (75 Ω IHF)
FM usable sensitivity (Mono)	11.2 dBf (75 Ω IHF)
FM signal-to-noise ratio (Stereo)	70 dB (IHF-A)
FM signal-to-noise ratio (Mono)	76 dB (IHF-A)
FM total harmonic distortion (Stereo)	0.3% (1 kHz)
FM total harmonic distortion (Mono)	0.2% (1 kHz)
FM frequency response	20 Hz–15 kHz, ±1.5 dB
FM stereo separation	45 dB (1 kHz)

AM Tuner Specifications

AM tuning frequency range	522 kHz–1, 611 kHz
AM usable sensitivity	30 µV/m
AM signal-to-noise ratio	50 dB
AM total harmonic distortion	0.7%

Weight and Dimensions

dimensions	435 x 81 x 310 mm
weight	3.2 kg