6
En
Update procedure
1
Connect a USB device to your PC. If
there is any data in the USB device,
remove it first.
2
Download the firmware file from the
Onkyo web site. The file name is as
follows:
ONKAVR****_************.zip
Unzip the downloaded file. The
following three files are created:
ONKAVR****_************.of1
ONKAVR****_************.of2
ONKAVR****_************.of3
3
Copy the extracted files to the USB
device. Be careful not to copy the zip
file.
4
Remove the USB device from your PC
and connect it to the USB port on the
AV receiver.
5
Make sure the AV receiver and TV are
turned on.
If the AV receiver is in standby mode,
press 8ON/STANDBY on the AV
receiver to light the front display.
6
Select the USB input source.
“Now Initializing...” is displayed on the
front display and then the name of the
USB device is displayed. It takes 20 to
30 seconds to recognize the USB device.
7
Press RECEIVER followed by SETUP
on the remote controller.
Setup menu will be displayed on the TV
screen. The procedures thereafter can
also be performed on the AV receiver by
using its SETUP, arrow and ENTER
buttons.
8
Select “Update” and press ENTER.
9
Select “Via USB” and press ENTER.
10
Select “Update” and press ENTER.
The update process will begin.
During the update process, the on-screen
display may disappear depending on the
updated program. When this occurs, you
can still view the update progress on the
front display of the AV receiver. The on-
screen display will reappear after the
update is complete, and upon turning the
AV receiver off and on again.
Do not turn off the AV receiver and do
not remove the USB device during the
update process.
To Next Page
Loading...
