Onkyo TX-NR509 - Updating the Firmware Via USB

5
En
The AV receiver allows you to update the
firmware using a USB device.
Note
• Make sure the AV receiver and TV are turned on.
• Never unplug or turn off the AV receiver during
the update process.
• Never plug or unplug an HDMI cable or a USB
device during the update process.
• Never unplug the USB storage device containing
the firmware file or the AC power cord during
the update process.
• Do not attempt to access the AV receiver from
your PC while it is being updated.
• It takes about 30 minutes to complete the
firmware update.
• The AV receiver will retain all your settings after
the update is finished.
Before you start
• Set the “HDMI Ctrl(RIHD)” setting to
“Off”.
• Turn off the controller device connected via
Ethernet cable.
• Turn off Zone 2.
• Stop playback of contents from Internet
Radio, iPod/iPhone, USB or servers, etc.
• If there is any data in the USB device,
remove it first.
■ How to turn off HDMI Control(RIHD)
Updating the Firmware via USB
1
Press RECEIVER followed by SETUP
on the remote controller.
2
Select “HDMI Setup” and press
ENTER.
3
Set “HDMI Ctrl(RIHD)” to “Off”.