Onkyo TX-NR5100 - Page 144

144
Appendix
(*1) You cannot select any mode other than Pure Audio, Direct, Stereo, AllCh Stereo and Mono Music if the sampling rate is 5.6/11.2 MHz.
(*2) A center speaker or surround speakers need to be installed.
(*3) If the input source is Blu-ray Disc and the speaker layout is 5.1 ch or less, DD+ cannot be selected. Instead, the listening mode for DD can be selected.
(*4) This can only be selected when no surround back speaker is connected.
(*5) Surround back speakers need to be installed.
(*6) If the input format is any of the following and the number of channels is monaural, this listening mode becomes unavailable.
– DTS, DTS 96/24, DTS Express, DTS-HD HR, DTS-HD MSTR, PCM, music le
(*7) Surround speakers or height speakers need to be installed.
(*8) A center speaker, surround speakers, or height speakers need to be installed.
(*9) Cannot be selected if "Speaker Virtualizer" ( →p100) is set to "O󰀨".
(*10) Cannot be selected when height speakers are installed.
(*11) Cannot be selected when the input format is monaural.
(*12) The listening mode displayed depends on the speaker layout ( →p136). Furthermore, when the setting for "Speaker Virtualizer" ( →p100) is "O󰀨" (the default
value is On), then modes other than Atmos and DSur cannot be selected
(*13) This cannot be selected when the input format is DTS Express.
 Speaker Layouts and Selectable Listening
Modes ( →p136)