Onkyo TX-NR5100 - General Specifications; Amplifier Section

151
Appendix
General Specications
Amplier Section
Rated Output Power
With 8 ohm loads, both channels driven, from 20-20,000 Hz; rated 80 watts per channel minimum RMS power,
with no more than 0.08% total harmonic distortion from 250 milliwatts to rated output. (FTC)
Maximum E󰀨ective Output Power 165 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
Dynamic Power (IEC60268-Short-term
maximum output power)
160 W (3 Ω, Front), 125 W (4 Ω, Front), 85 W (8 Ω, Front)
THD+N (Total Harmonic Distortion + Noise) 0.08% (20 Hz - 20,000 Hz, Rated output power)
Input Sensitivity and Impedance 200 mV/32 kΩ (LINE(RCA))
Rated RCA Output Level and Impedance
PRE OUT (SUBWOOFER) : 1 V/470 Ω
PRE/LINE OUT (ZONE B) : 200 mV/2.2 kΩ
Frequency Response 10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Audio)
Tone Control Characteristics ±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio 106 dB (IHF-A, LINE IN, SP OUT)
Speaker Impedance 4 Ω - 16 Ω
Headphone Rated Output 80 mW + 80 mW (32 Ω, 1 kHz, 10% THD)
Supported impedance of Headphones 8 Ω - 600 Ω
Headphones Frequency Response 10 Hz - 100 kHz