88
Playback
Connecting a transmitter for playback
When you connect wireless headphones or a wireless speaker transmitter to the ZONE B PRE/LINE OUT terminal of this unit, you can play back the same source
through the wireless headphones or wireless speakers as in the main room.
Connections
1. Use an analog audio cable to connect the ZONE B PRE/LINE OUT terminal
on this unit to the input terminal on the transmitter.
a
Transmitter
Playing Back
1. Press the Q button on the remote controller and select "Audio" - "Zone B".
2. Select the audio output destination.
O: Outputs audio only from ZONE A. "A" on the display of the main unit
lights up.
On (A+B): Outputs audio from both ZONE A and ZONE B. "A" and "B" on the
display of the main unit light up.
On (B): Outputs audio only from ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the volume on the transmitter, etc., in ZONE B.
• If "On (A+B)" is selected as an audio output destination, you can select only
the "Stereo" listening mode for ZONE A when using the 2.1 ch speaker layout.
When using a speaker layout of 3.1 ch or more, you can select only the "AllCh
Stereo" listening mode.
a Analog audio cable
To Next Page
Loading...
