Onkyo TX-NR5100 - 2. Speaker

96
SetupSetup
2. Speaker2. Speaker
 1. Conguration
Change the settings of connection environment of the speakers.
 Speaker Channels (Default Value: 7.1 ch)
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1 ch", "7.1 ch", "2.1.2 ch",
"3.1.2 ch", "4.1.2 ch", or "5.1.2 ch" to suit the number of speaker channels
connected.
 Subwoofer (Default Value: Yes)
Set whether a subwoofer is connected or not.
Yes When a subwoofer is connected
No When a subwoofer is not connected
 Height Speaker (Default Value: Top Middle)
Set the speaker type when height speakers are connected. Select from "Top
Middle", "Top Rear", "Rear High", "Dolby Speaker (Front)", "Dolby Speaker
(Surr)", "Front High" and "Top Front" according to the type and layout of the
connected speakers.
• If an item cannot be selected even though connection is correct, check
that the settings in "Speaker Channels" matches the number of connected
channels.
 Zone B Speaker (Default Value: No)
Set whether speakers are connected to ZONE B speaker terminals.
• This setting cannot be selected when "Speaker Channels" is set to "6.1 ch",
"7.1 ch", "4.1.2 ch" or "5.1.2 ch".
Yes When speakers are connected to ZONE B speaker terminals
No When speakers are not connected to ZONE B speaker
terminals
• This setting is xed to "No" when "Bi-Amp" is set to "Yes".
 Zone B Output Level (Default Value: Fixed)
When audio is output to ZONE B, set whether the volume is adjusted with the
integrated amplier in the separate room or with this unit.
• This setting is xed to "Variable" when "Zone B Speaker" is set to "Yes".
Fixed When adjusting with the integrated amplier in the separate
room
Variable When adjusting with this unit
 Bi-Amp (Default Value: No)
Set whether the front speakers are bi-amp connected.
• This setting cannot be selected when surround back speakers or height
speakers are used.
No When front speakers are not bi-amp connected
• This setting is xed to "No" when "Zone B Speaker" is set to
"Yes".
Yes When front speakers are bi-amp connected
 Speaker Impedance (Default Value: 6ohms or above)
Set the impedance (Ω) of the connected speakers.
• For impedance, check the indications on the back of the speakers or their
instruction manual.
4ohms When any of the connected speakers have 4 Ω or more to less
than 6 Ω impedance
6ohms or above When all the connected speakers have an impedance of 6 Ω
or more