Onkyo TX-NR5100 - Page 99

99
SetupSetup
2. Speaker
 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
• This setting can be selected when "Conguration" - "Height Speaker" is set to
"Dolby Speaker".
 Distance from the ceiling (Default Value: 6.0 ft/1.80 m)
Set the distance between the Dolby Enabled Speaker and the ceiling. Select
between "0.1 ft"/"0.03 m" and "15.0 ft"/"4.50 m" ("0.1 ft"/"0.03 m" units).
• The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
 AccuReex (Default Value: O󰀨)
You can enhance the reection e󰀨ect of Dolby Enabled Speakers from the
ceiling.
O󰀨 When this function is not used
On When this function is used
 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of di󰀨erent sound ranges for each speaker. You can set three
di󰀨erent equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to ve bands for the Subwoofer and nine bands
for the other speakers.
 Front (Default Value: 0.0dB)
Center (Default Value: 0.0dB)
Height (Default Value: 0.0dB)
Surround (Default Value: 0.0dB)
Surround Back (Default Value: 0.0dB)
Subwoofer (Default Value: 0.0dB)
After selecting the speaker frequency from between "25 Hz" and "16 kHz" ("25
Hz" and "160 Hz" for Subwoofer) with the cursors / , adjust the volume of that
frequency between "-6.0 dB" and "+6.0 dB" with / .
• Depending on the input source or listening mode setting, the desired e󰀨ect
may not be achieved.
(Subwoofer):
• This cannot be selected if "Conguration" - "Subwoofer" is set to "No".