Onkyo TX-NR929 - Precautions

TX-NR828/ 929/ DTR-50.5/ 60.5/ DHC-60.5
DEBUG MODE-1
AUDIO DEBUG MODE-1/4
To set in Debug mode
1. Press twice the ON/STANDBY key while pressing the DISPLAY key.
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
AUDIO DEBUG MODE (Display mode of the audio information)
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
Audio dubug mode
Step-1
Exit
e.g.
Ma in:
1 .01/1 3515 AE8
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
DS P 1st /NET :
1 .07/1 3514 AEA
e.g.
0A 0002: : 00
AN A: o: NO N: :
4. Press DISPLAY button.
SP 00F
*
00 F0040 9
4 8 4 8256 STB
2: o: PCM : PCM
0 0: x : F : O FF
1: ANA 048k 048k
2/ 0. 0: 2 . 0 : 3 /4
9. Press DISPLAY button.
8. Press DISPLAY button.
6. Press DISPLAY button.
5. Press DISPLAY button.
11. Press DISPLAY button.
12. Press DISPLAY button.
10. Press DISPLAY button.
7. Press DISPLAY button.
13. Press DISPLAY button.
LW : 0 0
RW : 0 0
LB : 0 0
RB : 0 0
LH : 0 0
RH : 0 0
LS : 0 0
RS : 0 0
C : 0 0
L : 0 0
R : 0 0
SW : 0 0
SW 2 : 0 0
Step-2
Step-11
Step-10
Step-9
Step-8
Step-7
Step-6
Step-5
Step-4
Step-3
14. Press DISPLAY button.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.