Onkyo TX-SR503E - Minimum Speaker Impedance Setup; Not North American Model

32
First Time Setup—Continued
If the impedance of any of the connected speakers is 4
ohms or more, but less than 6 ohms, set the Minimum
Speaker Impedance to “4 ohms.”
Note:
Before you change this setting, turn down the volume.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
This section explains how to specify which speakers are
connected and their sizes.
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify Large. For those with a
smaller diameter, specify Small.
Minimum Speaker Impedance Setup
(not North American model)
1
Press the [RECEIVER] button followed
by the [SETUP] button.
2
Use the Up and Down [ ]/[ ] buttons
to select “0. Hardware Setup,” and then
press [ENTER].
3
Use the Left and Right [ ]/[ ] buttons
to select the setting for “Impedance.”
4 ohms: Select if the impedance of any con-
nected speaker is 4 ohms or more, but
less than 6 ohms.
6 ohms: Select if the impedances of all con-
nected speakers are between 6 and
16 ohms.
Press [RETURN] to continue with step 2 in the
“Speaker Configuration” setting.
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A/ B
SETUPRETURN
--
/
---
TAPE/AMP
MD
CDR
CABLE
ON STANDBY
DIMMER SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
CDTAPE TUNER
DVD
MULTI CH
LISTENING MODE
TV
SU
RR
OU
ND
S
TERE
O
VOL
VOL
SAT
VCR
TV
DVD
RECEIVER
CD
INPUT
+
10
0
CLR
123
456
789
ENTER
CH
DISC
RETURN
1
1, 9
2–8
Speaker Configuration
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker
Config,” and then press the
[ENTER] button.
3
While the Subwoofer setting is
selected, use the Left and Right
[ ]/[ ] buttons to select Yes or
No.
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
Use the Down [ ] button to
select “Front,” and then use the
Left and Right [ ]/[ ] buttons to
select Small or Large.
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
Cone diameter