Onkyo TX-SR573 - First-Time Setup Procedures; Assigning Digital Inputs; Changing Input Display Names

31
First Time Setup
To enjoy Dolby Digital and DTS sources, you must con-
nect your DVD player to the AV receiver digitally (coax-
ial or optical).
With this function, you can assign digital inputs to input
sources. If, for example, you connect your DVD player
to the DIGITAL IN OPTICAL 1 input (OPT1), you’ll
need to assign it to the DVD input source, as follows.
Note:
Make sure that components connected digitally are con-
figured to output digital audio. Refer to the relevant man-
uals.
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 2 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
iPod photo: If you’re using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the VIDEO 2 IN jacks.
Note:
HDD can be selected for the TAPE input selector or
VIDEO 2 input selector, but not both at the same time.
Assigning Digital Inputs to Sources
1
Press the input selector button
for the input source that you want
to assign.
(Digital inputs cannot be assigned to
the TUNER input source.)
2
Press the [DIGITAL INPUT]
button.
The current assignment appears.
3
Press the [DIGITAL INPUT] but-
ton repeatedly to select COAX,
OPT1, OPT2, OPT3, or “– – – –”
(analog).
TONE
+
STEREO
LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES
MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD
VIDEO
VIDEO 3 INPUT
AUDIO LR
MASTER VOLUME
A SPEAKERS B
2, 3
1
DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER
CD
DIGITAL INPUT
DIGITAL INPUT
Changing the Input Display
1
Press the [TAPE] or [VIDEO 2]
input selector button so that
“TAPE” or “VIDEO 2” appears on
the display.
2
Press and hold down the [TAPE]
or [VIDEO 2] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
HDD.
For the TAPE input selector, the setting
changes in this order:
TAPE
→ MD → CDR → HDD
For the VIDEO 2 input selector, the set-
ting changes in this order:
VIDEO 2
↔ HDD
TONE
+
STEREO
LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES
MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD
VIDEO
VIDEO 3 INPUT
AUDIO LR
MASTER VOLUME
A SPEAKERS B
1, 21, 2
TAPE
VIDEO 2
or
TAPE
VIDEO 2
or
→