EasyManuals Logo

Onkyo TX-SR800 Service Manual

Onkyo TX-SR800
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
TX-SR800
SERVICE MANUAL
SERVICE MANUAL
Black and Golden models
Ref. No. 3754
112002
STANDBY/ON
STANDBY
PHONES
MASTER VOLUME
TAPE TUNER PHONO C
D
VIDEO
4
VIDEO
5
VIDEO
3
VIDEO
2
VIDEO
1
DVD
OFFZONE
2
REC OUTDISPLAY DIMMER
AUDIO
SELECTOR
ZONE
2
()
GRN
REC
()
RED
VCR
2
VCR
1
S VIDEO AUDIO
VIDEO L R
DIGITAL
VIDEO
5
INPUT
OFF
ON
POWER
TX
-
SR800
PURE AUDIO
UPSAMPLING
CLEAR
DSP
A
-
FO
RM LISTENING MODE MEMORY
THX
SURROUNDDIRECT
/
PURE AUDIO STEREO
FM
MODE
MEMORY
ENTER
RE
TURN
SETUP
TUNING
PRESET
AV RECEIVER
MODEL
TX-SR800
BMDD,BMDC 120V AC, 60Hz
BMPA,GMPA 230~240V AC, 50Hz
BMWT,GMWT,GMWR 120/220~230V AC, 50/60Hz
GMGT 220V AC, 50Hz
SAFETY-RELATED COMPONENT
WARNING!!
COMPONENTS IDENTIFIED BY MARK ON THE
SCHEMATIC DIAGRAM AND IN THE PARTS LIST ARE
CRITICAL FOR RISK OF FIRE AND ELECTRIC SHOCK.
REPLACE THESE COMPONENTS WITH ONKYO
PARTS WHOSE PART NUMBERS APPEAR AS SHOWN
IN THIS MANUAL.
MAKE LEAKAGE-CURRENT OR RESISTANCE
MEASUREMENTS TO DETERMINE THAT EXPOSED
PARTS ARE ACCEPTABLY INSULATED FROM THE
SUPPLY CIRCUIT BEFORE RETURNING THE
APPLIANCE TO THE CUSTOMER.

Other manuals for Onkyo TX-SR800

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo TX-SR800 and is the answer not in the manual?

Onkyo TX-SR800 Specifications

Amplifier Specifications IconAmplifier Specifications
continuous average power output100 W per channel min. RMS at 8 Ω, 130 W min. RMS at 6 Ω
continuous power output (DIN)135 W at 6 Ω
maximum power output (EIAJ)160 W at 6 Ω
dynamic power output (stereo)2 × 250 W at 3 Ω, 2 × 210 W at 4 Ω, 2 × 130 W at 8 Ω
total harmonic distortion0.08% at rated power
IM distortion0.08% at rated power
damping factor60 at 8 Ω
Input Specifications IconInput Specifications
phono input sensitivity and impedance2.5 mV, 50 kΩ
line input sensitivity and impedance200 mV, 50 kΩ
multichannel input sensitivity and impedance200 mV, 50 kΩ
subwoofer input sensitivity and impedance36 mV, 50 kΩ
coaxial input sensitivity and impedance0.5 Vp-p, 75 Ω
video input sensitivity and impedance1 Vp-p, 75 Ω
Output Specifications IconOutput Specifications
rec out level and impedance200 mV, 470 Ω
pre out level and impedance1 V, 470 Ω
video output level and impedance1 Vp-p, 75 Ω
component video output level and impedance1 Vp-p, 75 Ω (Y), 0.7 Vp-p, 75 Ω (PB, PR)
Frequency Response & Tone Control IconFrequency Response & Tone Control
frequency response10 Hz to 100 kHz : +1/–3 dB
RIAA deviation20 Hz to 20 kHz : ±0.8 dB
bass tone control±10 dB at 50 Hz
treble tone control±10 dB at 20, 000 Hz
signal-to-noise ratio (direct) phono80 dB (IHF A, 5 mV input)
signal-to-noise ratio (direct) line110 dB (IHF A, 0.5 V input)
FM Tuner Specifications IconFM Tuner Specifications
FM tuning range87.5–108.0 MHz (USA & Canadian models), 87.50–108.00 MHz (Other models)
usable sensitivity mono11.2 dBf, 1.0 µV (75 Ω IHF)
usable sensitivity stereo17.2 dBf, 2.0 µV (75 Ω IHF)
50 dB quieting sensitivity mono17.2 dBf, 2.0 µV (75 Ω)
50 dB quieting sensitivity stereo37.2 dBf, 20 µV (75 Ω)
capture ratio2.0 dB
image rejection ratio40 dB (USA & Canadian models), 85 dB (Other models)
IF rejection ratio90 dB
signal-to-noise ratio mono76 dB
signal-to-noise ratio stereo70 dB
alternate channel attenuation55 dB
selectivity50 dB (DIN)
AM suppression ratio50 dB
total harmonic distortion mono0.2%
total harmonic distortion stereo0.3%
frequency response30 Hz–15 kHz, ±1.0 dB
stereo separation45 dB at 1 kHz
AM Tuner Specifications IconAM Tuner Specifications
AM tuning range530 to 1, 710 kHz (USA & Canadian models), 522 to 1, 611 kHz (Some Asian and Australian models), 522 to 1, 611 kHz (Worldwide models)
usable sensitivity30 µV
image rejection ratio40 dB
IF rejection ratio40 dB
signal-to-noise ratio40 dB
total harmonic distortion0.7%
General Specifications IconGeneral Specifications
power supplyAC 120 V, 60 Hz (USA & Canadian models), AC 230–240 V, 50 Hz (Australian models), AC 220–230 V, 50/60 Hz (Some Asian models), AC 220–230 and 120 V switchable, 50/60 Hz (Worldwide models)
power consumption8.1 A (USA & Canadian models), 655 W (Other models)
dimensions435 × 175 × 459 mm
weight35.9 lbs. (USA & Canadian models), 17.3 kg (Other models)
Remote Controller Specifications IconRemote Controller Specifications
transmitterInfrared
signal rangeApprox. 16 ft., 5 meters
power supplyTwo “AA” batteries (1.5 V × 2)

Related product manuals