Onkyo TX-SR800

76 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

11

Index parts and facilities

Remote controller

The RC-510M is a multi-functional remote controller. The

instructions given here only explain how to use the remote controller

in conjunction with the TX-SR800. To operate the TX-SR800 using

the remote controller, first press the RCVR MODE button to place

the remote controller in the receiver mode.

Table of Contents

Default Chapter1
- Instruction Manual1
Before Using Important Safeguards2
Precautions3
Contents4
- Table of Contents4
Features6
Supplied Accessories6
Before Using this Unit7
- Setting the Voltage Selector (Worldwide Models Only)7
- Installing the Remote Controller Batteries7
- Using the Remote Controller7
Index Parts and Facilities8
- Front Panels8
- Front Panel Display10
- Remote Controller11
- Rear Panel13
Connecting to Audio/Video Equipment14
- Connecting Your Audio Components15
- Connecting Your Video Components16
Connecting Speakers20
- Ideal Speaker Configuration20
- Minimum Speaker Configuration for Surround Sound Playback20
- Speaker Placement20
- Connecting Speakers21
- Using the Speaker Labels21
Connecting Antennas22
- Assembling the am Loop Antenna22
- Connecting the am Antenna Cable22
- Connecting the Included Antennas22
- Connecting an FM Outdoor Antenna23
- Connecting an am Outdoor Antenna23
- Directional Linkage23
- Connecting the Antenna Cable to the 75/300 Ω Antenna Adapter23
- (For All Models Other than USA & Canadian Models)23
Connecting the Remote Zone (Zone 2) Speakers24
- When Using the SURR BACK/ZONE 2 SPEAKERS Terminals24
- When Using the SURR BACK/ZONE 2 PRE out Terminals24
- Connecting the TX-SR800 to the Monitor for the Remote Zone24
Operating Components Not Reached by the Remote Controller Signals (IR IN/OUT)25
- If the Remote Controller Signal Does Not Reach the TX-SR800 Remote Sensor25
- If the Remote Controller Signal Does Not Reach Other Components25
Miscellaneous Connections26
- Connecting for Remote Control ( )26
- Connecting the Power Cords from Other Devices26
- Connecting to Devices with Analog Multi Channel Output27
- Connecting Auxiliary Power Amplifier27
Connecting the Power28
- Turning on the Power28
- Turning on the Power from the Remote Controller28
Enjoying Music or Videos with the TX-SR80029
- Basic Operation29
- To Change the Display of the Input Source from TAPE to MD29
- Temporarily Turning off the Sound30
- Adjusting the Bass and Treble30
- Listening with Headphones30
- Using the Sleep Time (Remote Controller Only)30
- Changing the Listening Mode31
- Switching the Display32
- Adjusting the Brightness of the Front Display32
- Temporarily Changing the Speaker Output Levels32
- Changing the Audio Mode33
- Enjoying the Multichannel Output33
Listening to Radio Broadcasts34
- Tuning into a Radio Station34
- Listening to a Stereo Radio Station (FM Mode)34
- Presetting a Radio Station35
- Selecting a Preset Radio Station35
- Erasing a Preset Radio Station35
Enjoying Music in the Remote Zone36
- Using the Buttons on the TX-SR80036
- Using the Remote Controller36
- Adjusting the Volume for the Remote Zone36
Recording a Source37
- To Record the Input Source Signal You Are Currently Watching or Listening to37
- To Record an Input Source Signal Different from that You Are Currently Watching or Listening to37
- Recording the Video from One Source and the Audio from Another38
Setup Menu39
- Navigating through the Setup Menu40
Hardware Setup41
- Speaker Impedance Sub-Menu41
- Surr Back/Zone 2 Sub-Menu41
- AM Frequency Step Sub-Menu (Worldwide Model Only)42
- IR in Setup Sub-Menu42
- Hardware Setup Menu41
Speaker Setup43
- 1 Speaker Setup Menu43
- Speaker Config Sub-Menu43
- Speaker Distance Sub-Menu44
- Level Calibration Sub-Menu45
Input Setup46
- 2 Input Setup Menu46
- Digital Setup Sub-Menu46
- Multichannel Setup Sub-Menu47
- Video Setup Sub-Menu48
- Character Input Sub-Menu49
- Intellivolume Sub-Menu49
- Listening Mode Preset Sub-Menu50
Audio Adjust53
- 3 Audio Adjust Setup Menu53
- Surround Speakers Sub-Menu53
- Tone Control Sub-Menu53
- Delay Sub-Menu54
- Sound Effect Sub-Menu54
- LFE Level Sub-Menu55
- Mono Sub-Menu55
- Theater Dimensional Sub-Menu55
- Surround Sub-Menu56
- Mono Movie/Enhanced57
- Orchestra/Unplugged/Studio MIX /TV Logic Sub-Menu57
- THX Sub-Menu57
Preference59
- 4 Preference Menu59
- Volume Setup Sub-Menu59
- Headphones Level Setup Sub-Menu60
- OSD Position Sub-Menu60
- OSD Setup Sub-Menu60
Remote Controller61
Using Remote Controller61
- Overview61
- Controlling an Onkyo Cassette Tape Deck61
- Controlling an Onkyo DVD Player62
- Controlling an Onkyo CD Player63
- Controlling an Onkyo MD Recorder64
Entering a Pre-Programming Code65
- Learning a Pre-Programming Code65
- Pre-Programming Codes66
Operating Your Programmed Remote Controller67
- DVD MODE (DVD Player Mode)67
- SAT MODE (Satellite Tuner Mode)67
- CABLE MODE (Cable Mode)67
- VCR MODE (VCR Mode)68
- TV MODE (TV Mode)68
Programming the Commands of Remote Controllers for Other Devices into the Remote Controller69
- Programming Procedure69
- Erasing the Programmed Command from One Button70
- Erasing All the Commands Programmed under a MODE Button70
Using the Macro Function71
- What Is the Macro Function71
- Programming the Macro71
- Executing the Macro71
- Erasing a Macro from the MACRO 1 (or 2) Button72
- Erasing All Commands and Macros that Have Been Programmed72
Appendix Troubleshooting Guide73
- Power73
- Speakers73
- Fm/Am Tuner73
- VIDEO and AUDIO74
- Remote Controller74
- Other74
- If One of the Messages Shown below Appears75
Specifications76

Other manuals for Onkyo TX-SR800

Service Manual88 pages

Related product manuals

Preview: Onkyo TX-SR805

Preview: Onkyo TX SR804

Preview: Onkyo TX-SR806

Preview: Onkyo TX-SR876

Preview: Onkyo TX-SR604

Preview: Onkyo TX-SR313

Preview: Onkyo TX SR608

Preview: Onkyo TX-SR506

Preview: Onkyo TX-SR500

Preview: Onkyo TX-SR607

Preview: Onkyo TX-SR602