Onkyo TX-SR800

42
Hardware Setup
Advanced Menu
0.Hardware Setup
0-4.AM Frequency Step
a.Frequency Step
:9 kHz
0-4. AM Frequency Step Sub-menu
(Worldwide model Only)
a. Frequency Step
This sub-menu only appears on the worldwide model. The setting in
this sub-menu determines the increment amount or decrement
amount when adjusting the AM tuner frequency. The initial setting is
9 kHz, and this needs only to be changed if you are using the TX-
SR800 in a 10-kHz region.
0-3. IR IN Setup Sub-menu
This sub-menu allows you to set where you will be using the remote
controler when you are using it in conjunction with the IR IN
terminal. (i.e. remote controller signals are input at the IR IN
terminal)
Main: Select when you have a remote sensor for the remote
controller connected to the IR IN terminal in the main room.
Zone 2: Select to perform the remote zone (Zone 2) opereations
from the remote zone.
Advanced Menu
0.Hardware Setup
0-3.IR IN Setup
a.Position :Main
Quit:|SETUP|