Onkyo TX-SV535 - IC Block Diagrams: DRAM and FL Tube

Connection for Multiple-Room Remote Control
U.S.A. and Canadian models (Xantech Multiple-Room systems)
Do not plug in the power cord until all connections have been made.
When making connections V through '5;, be sure to connect the units as show n in the connection diagram below'. Do not make a mistake when
conncctimz the units.
A. Operating components displaying Onkyo’s Rl mark from the sub-room
Components mounted in a rack should be connected as shown below to enable remote control operation.
1. Set up the components (a) displaying
Onkyo’s RI mark.
2. Connect the speaker B cables to the
speaker terminal on the TX-SV535.
( ' )
3. Install Connecting Block 789-40 in the
main room, then connect it to the TX-
SV535. ( 2 )
(Connect Power Supply 781C-00 or
782-00 to the Connecting Block.)
4. Install Xantech’s J-Box Receiver 780-
10 or Dinky Link 480B-00 in the sub-
room, then connect it to the Connect¬
ing Block in the main room. ( 3 )
B. Using a remote control to operate components not displaying Onkyo’s Rl mark from the sub-room
1. Connect the components (b) to the
TX-SV535.
2. Make the connections described above
in steps 2 through 4 of section A.
3. Install Emitter 282-00 (c) so that its
sensor is directed toward these com¬
ponents, then connect it to the TX-
SV535. ( 4 )
■ Operating components which
are positioned out of the range of
the emitter installed as described
above
4. Connect the components (d) to the
TX-SV535.
5. Install another Emitter 282-00 (e) so
that its sensor is directed toward these
components, then connect it to the
Connecting Block 789-40. ( 5 )
Speaker A (Main Room) Connecting Emitter
SUB ROOM