Onkyo TX-SV535 - Block Diagram: Tuner Section (120 V Model)

Audio equipment connections
On each pair of input jacks, the lower jack (marked R: Red) corresponds to the
right channel, and the upper jack (marked L: White) to the left channel.
Please refer to the instruction manual of each component when making any connec¬
tions.
A cassette tape deck and compact disc player that have the ONKYO RI
mark can be operated using the accessory remote control with this unit.
Connect a remote control cable to the black jack with the Rl mark.
Never connect it to the green or gray jack with the fTR^ mark.
Connect the remote control cable as shown right side to enable remote
control operation of other components. ( ® )
NOTES:
• To enable proper remote control operation, both the Rl cable and
the audio cables must be connected between units.
• This unit’s remote control cannot be used to control ONKYO turn¬
tables.
• An Rl remote control cable equipped with a 1/8” (3.5 mm) minia¬
ture 2 conductor phone plug is included with this unit and with any
other component with the RI mark.
^- - -=j=iui- -..Y1Y"
The SWITCHED outlet is switched on and off by the power buttons
on the front panel and remote control. For AC outlet connection
details, refer to E in the illustration at the left.
The shape, number and total capacity of the AC outlets may differ
according to the model and the area where the unit is purchased. Be
careful that other components connected to this unit do not exceed the
capacity that is printed on the rear panel above the AC outlets.
8