Onkyo TX-SV535 - Using the Tuner

Using the tuner
Please make sure that the TAPE-2 MONITOR indicator is off and audio muting is off.
2
FM MUTE/MODE 1,
When the frequency is not known-Manual tuning
1. Press the FM or AM button.
2. Use the ◄ DOWN TUNING UP ► buttons to change the fre¬
quency.
UP.the frequency increases.
DOWN ....the frequency decreases.
• The frequency is changed in 50 kHz steps in FM and 10 kHz (or
9kHz) in AM when the tuning selector button is pressed in single
steps.
• If this button is held continuously for more than 0.5 seconds, the
frequencies are scanned automatically. (EM auto tuning mode)
When a broadcast is received, scanning stops.
When the frequency is known-Direct tuning
. Press the FM or A\I button.
. Press the DIRECT TUNING button.
The "-" will Hash 16 seconds in the frequency display.
Enter the frequency with the number buttons while the cursor
are flashing.
Example: 88.10 MHz 8 -> 8 -> 1 -> 0/10
• When receiving AM broadcasts with a 9 kHz step (this depending
on your region), you can enter the frequency directly.
• With 10 kHz steps, entering a number for the 10 kHz digit will set
the 1 kHz digit automatically to 0.
• If you enter a frequency that docs not have a station, this unit will
automatically tune to the next station immediately below that sta¬
tion.
• If you enter a frequency that is out of range, this unit w ill return to
the previous frequency . If this happens, repeat the procedure.
- Listing to a stereo radio stations (FM only) .
If you tune in a stereo FM station, the STEREO indicator w ill be illu¬
minated if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune in to your desired
station. In this case, tunc in as follows.
Press the FM MUTE/MODE button and FM MUTE OFF lights, At
this time, the station will be in mono and interstation noise will be
heard. Select the station you want listen to.
20