19
Small MDUs (12 or less units)
Openreach will create a bre layout based on
your Mechanical & Electrical (M&E) drawings
(on larger MDUs) of the MDU. The design
will calculate the stores required to build
the network.
Your FBC is on hand to guide you through the
ordering process to make sure the equipment is
available when you need it.
The incoming Duct 54zv and bre cable will
terminate in the communications intake room
or riser cupboard. This needs to be a secure and
safe location with access for installation and any
future maintenance visits.
Our bre box/splitter needs to be installed at
a minimum height of 200mm and a maximum
of 1500mm. Your FBC will agree the location
with you.
Connectorised internal bre cable needs to be
run from each plot to the bre DP location.
A minimum of 3m of coiled cable needs to be left
at the bre DP, with 1m left at the plot end.
A wayleave may be required from the building
owner prior to installing apparatus in common
areas. Remember you may need to order
copper, for example: for lift lines.
Multi Dwelling Units (MDUs)
5
How to build a fibre network - version 7.1
To Next Page
Loading...