Opticon OPN2002 - Connecting to Your Barcode Reader

13
3.2 Connecting to your barcode reader
After pairing your barcode reader first make sure the blue LED of the barcode reader
is still blinking to indicate it's still discoverable and connectable. If this isn't the case,
then read the label again to make your OPN2002 or OPL2724 discoverable and
connectable again.
Go to your applications and
start OpticonRL
Press 'Connect a device'
Important note:
The 'Enable auto connect' option is intended to automatically re-establish the
connection when the barcode reader was out of range for a about 2 minutes.