In the Receive Files(s) Dialog the task can be configured as shown in the following image.
Finally, select ‘Options’ > ‘Start Protocol’.
More information about additional OseComm32 features can be found in the help file of OseComm32.
9.2 Neto32
When the USB-VCP interface has been selected (see chapter 3.1) and the NetO protocol (see Appendix A), then the
barcode database file can be transmitted to a remote PC or laptop using NetO32. The data is transmitted by the USB
cable (USB-VCP). To be able to receive the files on the host, you'll need NetO32 to be installed. The latest version of
NetO32 can be downloaded from our web site under 'Service and support' > 'Software' > 'Neto32'. More information
about additional Neto32 features that aren't described in this manual can be found the help file of NetO32.
Screenshot of the main window of NetO32
To Next Page
Loading...
Need help?
General
