Optima Scale OP-918 - Page 12

10
CALIBRATION cont.
26. Press SET to continue. The display will now show
C07
.
27. Short press ON/OFF
to save and exit the setup menu.
28. The scale has now been calibrated. The display will show the value of the calibration
weight on the scale.
29. If the scale does not show the value of the calibration weight, check that the pallet
jack is level on the ground and on a at surface and recalibrate
30. Unload the scale; the display should read
000000
. If so, calibration is complete.
31. If the scale does not display 000000, check that the check that the pallet jack is lev-
el on the ground and on a at surface