Optimum OPTIdrill D17 Pro - Page 4

Version 1.0.3 - 2022-04-06 4 Originalbetriebsanleitung
D17 Pro│D23 Pro│D26 Pro│D33 Pro
EN
D17Pro_D23Pro_D26Pro_D33Pro_DE_GBIVZ.fm
1.15 Safety during operation................................................................................................................................ 71
1.16 Safety during maintenance.......................................................................................................................... 72
1.16.1 Disconnecting and securing the drilling machine ........................................................................... 72
1.17 Using lifting equipment ................................................................................................................................ 72
1.17.1 Mechanical maintenance ............................................................................................................... 72
1.18 Accident report............................................................................................................................................. 72
1.19 Electronics ................................................................................................................................................... 72
1.20 Inspection deadlines.................................................................................................................................... 73
2 Technical specification
2.1 Emissions .................................................................................................................................................... 75
2.2 Dimensions.................................................................................................................................................. 76
2.2.1 D17 Pro.......................................................................................................................................... 76
2.2.2 D23 Pro.......................................................................................................................................... 77
2.2.3 D26 Pro.......................................................................................................................................... 78
2.2.4 D33 Pro.......................................................................................................................................... 79
3 Delivery, interdepartmental transport, assembly and commissioning
3.1 Notes on transport, installation, commissioning .......................................................................................... 80
3.1.1 General risks during internal transport ........................................................................................... 80
3.2 Delivery........................................................................................................................................................ 81
3.3 Unpacking.................................................................................................................................................... 81
3.4 Assembly ..................................................................................................................................................... 81
3.5 Installation requirements.............................................................................................................................. 85
3.5.1 Foundation and ground.................................................................................................................. 85
3.5.2 Fixing.............................................................................................................................................. 85
3.6 First commissioning..................................................................................................................................... 88
3.7 Electrical connection.................................................................................................................................... 88
3.7.1 Warming up the machine ............................................................................................................... 89
4Operation
4.1 Control and indicating elements .................................................................................................................. 90
4.2 Control panel ............................................................................................................................................... 91
4.3 Switching on the machine............................................................................................................................ 91
4.4 Switching off the machine............................................................................................................................ 91
4.5 Drill depth..................................................................................................................................................... 91
4.5.1 Drill depth stop ............................................................................................................................... 91
4.5.2 Digital drilling depth........................................................................................................................ 92
4.6 Table Inclination........................................................................................................................................... 92
4.7 Speed variation............................................................................................................................................ 93
4.7.1 Speed tables .................................................................................................................................. 93
4.7.2 Rotational speed display ................................................................................................................ 96
4.8 Before starting work..................................................................................................................................... 96
4.9 During work.................................................................................................................................................. 96
4.10 Spindle sleeve feed ..................................................................................................................................... 96
4.11 Disassembly, assembly of drill chucks and drill bits .................................................................................... 97
4.12 Quick action - drill chuck.............................................................................................................................. 97
4.12.1 Fitting the drill chuck ...................................................................................................................... 98
4.13 Cooling......................................................................................................................................................... 98
5 Determining the cutting speed and the speed
5.1 Table cutting speeds / infeed....................................................................................................................... 99
5.2 Speed table.................................................................................................................................................. 99
5.2.1 Examples to calculatory determine the required speed for your drilling machine ........................ 101
6 Maintenance
6.1 Safety......................................................................................................................................................... 102
6.1.1 Preparation................................................................................................................................... 102
6.1.2 Restarting..................................................................................................................................... 102
6.2 Inspection and maintenance...................................................................................................................... 103
6.3 Repair ........................................................................................................................................................ 107