Version 1.1.0 - 2020-08-0728 Translation of original instruction
MH35G│MH35V
EN
MH35G_MH35V_GB_3.fm
3.7.1 Gear
3.8 Cleaning and lubrication
Remove the anti-corrosive agents which has been applied to the milling machine for trans-
port and storage. We recommend you use paraffin for this purpose.
To clean the milling machine, do not use any solvents, nitro-cellulose thinner or other clean-
ing agents that could damage the paintwork. Observe the cleaning agent manufacturer's
information and notes.
Grease all exposed machine parts using an acid-free lubricating oil.
Lubricate the milling machine in accordance with the lubrication schedule.
Inspection and maintenance on page 42
Check that all spindles are running smoothly. All spindle nuts are re-adjustable.
Check the oil level of the spindle gearbox.
INFORMATION
Lubricant on page 75
The milling machine has been painted with varnish. This fact must be taken into account when
selecting your cooling lubricant.
Fill cap
Sight glass
Oil outlet
To Next Page
Loading...
