Version 1.1.0 - 2020-08-078 Translation of original instruction
MH35G│MH35V
EN
MH35G_MH35V_GB_1.fm
1.3 Intended use
WARNING!
In the event of improper use, the milling machine
may be a hazard to personnel,
the machine and other property of the operating company and
the functionality of the milling machine may be compromised.
The milling machine is designed and manufactured to be used for milling and drilling cold met-
als or other non-flammable materials or materials that do not constitute a health hazard when
commercial milling and drilling tools are used.
The milling machine must only be installed and operated in a dry and well-ventilated areas.
If the milling machine is used in any way other than described above, or modified without the
approval of Maschinen Germany GmbH, then the milling machine is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH. It is
also part of the intended use that you
observe the limits of the milling machine,
observe the operating instructions,
and comply with the inspection and maintenance instructions.
Technical specification on page 19
Warning: automatic start-
up!
Warning: tilting danger! Warning: suspended loads! Caution: danger of
explosive substances!
Switching on forbidden!
Operating with rotary
current plug is not
permitted!
Read the operating
instructions before
commissioning!
Pull out the mains plug!
Wear protective glasses! Wear protective gloves! Wear safety shoes! Wear a protective suit!
Use ear protection! Only switch during
standstill!
Protect the environment!
Contact address
To Next Page
Loading...
