Optimum OPTIsaw SQ-V13 - Storage Requirements; Installation Site Requirements; First Commissioning Steps

Version 1.0.1 - 2020-9-30 10 Translation of original instruction
SQ-V13
EN
SQ-V13_GB.fm
time being in the status at which you have determined the damage or to take photos of this sta-
tus. Please inform us about any other claims within six days after receipt of delivery.
Check if all parts are firmly seated.
3.3 Storage
ATTENTION!
Incorrect and improper storage might result in damage or destruction of electrical and
mechanical machine components.
Store packed and unpacked parts only under the intended environmental conditions.
Follow the instructions and information on the transport box.
Consult Optimum Maschinen Germany GmbH if the machine and accessories are stored for
more than three months or are stored under different environmental conditions than those spec
-
ified here.
3.4 Set-up and assembly
3.4.1 Installation site requirements
Organize the working area around the metal band saw according to the local safety regulations.
INFORMATION
In order to achieve high levels of functionality and machining accuracy, as well as a long ser-
vice life of the machine, the set-up location should meet certain criteria.
The following points should be noted:
 The device must only be installed and operated in a dry and well-ventilated place.
 Avoid places close to machines which cause chips or dust.
 The installation site must be vibration-free, i.e. located away from presses, planing
machines, etc.
 The substructure must be suitable for metal band saws.
 Any parts sticking out such as stops, handles, etc. have to be secured by measures taken
by the customer if necessary in order to avoid endangering persons.
 Provide enough space for set-up and operating personnel and material transport.
 Also bear in mind accessibility for installation and maintenance works.
 Ensure adequate lighting is available (minimum value: 500 Lux, measured at the tool tip). In
the event of a lower level of lighting, additional illumination must be provided, e.g. by means
of a separate workplace light.
 The mains plug of the metal belt saw must be freely accessible.
CAUTION!
Position the power lead for the machine in such a manner that people cannot trip over it.
3.5 First commissioning
ATTENTION!
Before commissioning the machine, all bolts, fastenings and protections must be
checked and retightened as necessary!
WARNING!
Danger from the use of unsuitable saw bands. Only use saw bands that can withstand
the speed requirements and loads that occur.