Version 1.0.1 - 2020-9-30 8 Translation of original instruction
SQ-V13
EN
SQ-V13_GB.fm
1.12 Disconnecting and securing the metal band saw
Disconnect the mains plug before starting maintenance and repairs.
2 Technical specification
Emissions
The noise (emission) of the metal band saw is 75 dB(A) when idling. If several machines are
operated at the location of the metal band saw, the noise exposure (immission) to the operator
of the metal band saw at the workplace may exceed 80 dB(A).
INFORMATION
This numerical value was measured on a new machine under the operating conditions specified
by the manufacturer. The noise behaviour of the machine might change depending on the age
and wear of the machine.
Furthermore, the noise emission also depends on production engineering factors, e.g. speed,
material and clamping conditions.
INFORMATION
The specified numerical value represents the emission level and does not necessarily a safe
working level. Though there is a dependency between the degree of the noise emission and the
degree of the noise disturbance it is not possible to use it reliably to determine if further precau
-
Motor power 400 W
Operating mode, duty cycle S6 - 60%
Electrical connection 230V / ~50Hz
Cutting range 0° round material 125 mm
Cutting range 45° round material 85 mm
Cutting range 60° round material 50 mm
Cutting range 0° square material 125 mm
Cutting range 45° square material 85 mm
Cutting range 60° square material 50 mm
Cutting range 0° rectangular material 125 x 125 mm
Cutting range 45° rectangular material 85 x 85 mm
Cutting range 60° rectangular material 50 x 50 mm
infinitely variable saw band speed 30 m/min to 80 m/min
Saw band dimensions 1440 x 0.63 x 12.5 mm
Floor space approx. 382 x 613 mm
Net weight 23.3 kg
Packaging dimensions 400 x 470 x 750 mm
Ambient conditions temperature - 10°C to + 50°C -
Environmental conditions, Air humidity max. 90%
To Next Page
Loading...
