Version 1.0.1 - 2020-9-30 13Translation of original instruction
SQ-V13 EN
SQ-V13_GB.fm
4.8 Saw band tension
ATTENTION!
Excessive tensioning of the saw blade can lead to a loss of power and to the destruction of
components in the saw. Take care not to over-tension the saw band. Observe information on
saw band tension.
Changing the saw band on page 14
4.9 Use of coolant
WARNING!
Discharge and overflow of cooling lubricants and lubricants When using cooling
lubricants, make sure that they do not get on the floor. Any cooling lubricants that run
onto the floor must be removed immediately.
Use a suitable trough when using cooling lubricant.
ATTENTION!
Damage to electrical and electronic components if coolant penetrates through the fan
area of the motor.
Use cutting oils or cooling lubricants when sawing. Depending on the material of the work-
piece, however, dry machining can also take place, whereby the cleaning methods must be
adapted with regard to chip disposal.
5 Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repair
of the metal band saw.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the metal band saw and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1 Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
extremely serious injuries to those working on the metal band saw and
damage to the metal band saw.
Only qualified staff should carry out maintenance and repair work on the metal band
saw.
To Next Page
Loading...
