Optimum OPTIsaw SQ-V13 - Reasonably Foreseeable Misuse; Possible Dangers

Version 1.0.1 - 2020-9-30 5Translation of original instruction
SQ-V13 EN
SQ-V13_GB.fm
 obey the operating instructions,
 the inspection and maintenance instructions are observed.
The right choice of saw band, cutting pressure, cutting speed and coolant is essential to
achieve the required cutting performance and angle tolerance.
It is forbidden to make any modifications or alternations to the operation values of the metal
band saw! They could endanger people and cause damage to the metal belt saw.
ATTENTION!
If the metal band saw is not used as intended or if the safety directives or the operating
instructions are ignored the liability of the manufacturer for any damages to personnel
or objects resulting hereof is excluded and the claim under guarantee is becoming null
and void!
1.4 Reasonably foreseeable misuse
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use must be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be duly qualified.
1.5 Possible dangers caused by the metal band saw
The metal band saw was built using state-of-the-art technology. Nevertheless, there is a resid-
ual risk as the metal band saw operates with
 high speeds,
 rotating parts,
 electrical voltage and currents,
We have minimized the risk to people's health from these hazards through design and safety
technology.
If the metal band saw is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from incorrect or unsuitable maintenance of the metal band saw.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
 be duly qualified,
 and strictly follow these operating instructions.
Always disconnect the metal band saw from the electrical power supply before performing
cleaning or maintenance tasks.
WARNING!
The metal band saw may only be used with the safety devices activated.
Disconnect the metal band saw immediately whenever you detect a failure in the safety
devices or when they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices. This is your responsibility as the operator!