Optus X SLEEK - Getting Started

16
1.2 Getting started
1.2.1 Set up
Inserting or removing the SIM/microSD card
A nano card is required to make phone calls and use mobile networks.
If you have a SIM card, insert it before setting up the phone. Do not
attempt to insert mini-SIM card, as you may damage your phone.
Power off your phone before inserting or removing the SIM/microSD card.
Charging the battery
You are advised to fully charge the battery. Charging status is indicated
by a percentage displayed on screen while the phone is powered off. The
percentage increases as the phone is charged.
To reduce power consumption and energy waste, disconnect
your charger when the battery is fully charged; switch off Wi-Fi,
GPS, Bluetooth or apps running in the background when not
needed. In Settings you can also lower the brightness of the
screen, and shorten the length of time before the screen goes to
sleep.
1.2.2 Power on your phone
To turn your phone on, hold down the Power key until the phone powers
on. It will take a few seconds before the screen lights up. Unlock your
phone with a swipe, PIN, password or pattern before the Home screen
can display if you've set a screen lock in Settings.
If you do not know your PIN code or if you have forgotten it, contact
your network operator. Do not leave your PIN code with your phone.
Store this information in a safe place when not in use.
1.2.3 Power off your phone
To turn your phone off, hold down the Power key until the Phone options
appear, then select Power off.