11
Charging procedure
1. Place the Desktop Charger on a flat surface.
2. Connect the AC Adaptor lead to the Desktop Charger unit.
3. Plug the AC Adaptor into the mains supply (wall socket) and
switch on. The LED indicator on the Desktop Charger will
glow Red for 2 seconds.
4. If the battery is attached to the radio, ensure that the radio is
switched OFF.
5. Align the slots on the battery pack with the ridges in the
Desktop Charger and insert the radio/battery into the
Desktop Charger. The LED indicator on the Desktop Charger
will blink Red for a few seconds and then glow Red to show
that charging is in progress.
6. The approximate charging time for a flat battery is 4 hours.
7. When the LED indicator on the Desktop Charger glows
Green the battery is fully charged. Remove the battery/radio
from the Desktop Charger.
To conserve energy and reduce your environmental footprint
please disconnect the AC Adaptor from the mains supply when not
in use.
To Next Page
Loading...
Need help?
General